Section 01 Connections Installation 02 WARNING Do not use the unit in standard mode when a speaker system for 3-way network mode is connected to this unit. This may cause damage to the speakers. 2 To audio output 3 Connect with RCA cable (sold separately) 4 To audio input If connecting the unit to a car stereo with no RCA output 1 Use a thin, flathead screwdriver to change the DSP switch on the bottom of this unit. 12 3 4 5 7 8 6 2 Press RESET with a pen tip or other pointed instrument. For details, refer to the operation manual. Audio input If you connect the unit to an audio device with RCA output, or to one with no RCA output, you can set it up so that the audio from the audio device is output through speakers connected to the unit. Change settings as necessary based on whether the connected device has RCA output or not. For more details on change settings, refer to the operation manual or Switching between RCA input modes on this page. 1 Car stereo with no RCA output 2 To speaker output 3 Red: Right + 4 Black: Right * 5 Black: Left * 6 White: Left + 7 Speaker-RCA conversion cable (supplied) 19 cm 8 To audio input Switching between RCA input modes % Use a thin, flathead screwdriver to change the RCA input mode switch on the bottom of this unit. If connecting the unit to a car stereo with RCA output 2 3 4 1 ! L (Low) - If inputting from the RCA output of a connected device ! H (High) - If inputting from the speaker output of a connected device 1 Car stereo with RCA output 4 En Important ! Check all connections and systems before final installation. ! Do not use unauthorized parts as this may cause malfunctions. ! Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. ! Do not install this unit where: — it may interfere with operation of the vehicle. — it may cause injury to a passenger as a result of a sudden stop. ! The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet. ! Optimum performance is obtained when the unit is installed at an angle of less than 60°. Use commercially available parts when installing. DIN Front-mount 1 Insert the mounting sleeve into the dashboard. For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the vehicle. 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 1 60° 2 ! When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. Leave ample space 5 cm 1 Dashboard 2 Mounting sleeve 3 Install the unit as illustrated. 1 2 3 4 5 cm 5cm 5 DIN front/rear mount This unit can be properly installed using either front-mount or rear-mount installation. 1 Nut 2 Firewall or metal support 3 Metal strap 4 Screw 5 Screw (M4 × 8)
Download PDF file