Pioneer Car—Page 3

Pioneer CarConnections Connections Section 01 English e ISO connector In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Power amp (sold separately) Standard mode with internal amp Important ! Change the DSP switch to standard mode (STD). For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. ! The following signals are output from the speaker leads when this connection is in use. White: Front left + White/black: Front left * Gray: Front right + Gray/black: Front right * Green: Rear left + Green/black: Rear left * Violet: Rear right + Violet/black: Rear right * 1 3 2 4   5 5   1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To subwoofer output 5 Subwoofer Standard mode without internal amp Important ! Change the DSP switch to standard mode (STD). For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. ! If using this system, we recommend that this unit’s internal amp is turned off. For details, refer to the operation manual. ! The speaker leads are not used when this connection is in use. 1 3 2 4   5 5   3 1 2 6   7 7   3 2 1 8   9 9   1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To Rear output 5 Rear speaker 6 To Front output 7 Front speaker 8 To subwoofer output 9 Subwoofer 3-way network mode with internal amp Important ! Change the DSP switch to 3-way network mode (NW). For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. ! The following signals are output from the speaker leads when this connection is in use. White: Middle range left + White/black: Middle range left * Gray: Middle range right + Gray/black: Middle range right * Green: High range left + Green/black: High range left * Violet: High range right + Violet/black: High range right * 1 3 2 4   5 5   1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To low range output 5 Low range speaker 3-way network mode without internal amp Important ! Change the DSP switch to 3-way network mode (NW). For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. ! If using this system, we recommend that this unit’s internal amp is turned off. For details, refer to the operation manual. ! The speaker leads are not used when this connection is in use. 1 3 2 4   5 5   3 1 2 6   7 7   3 2 1 8   9 9   1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To high range output 5 High range speaker 6 To middle range output 7 Middle range speaker 8 To low range output 9 Low range speaker Switching the DSP setting mode This unit features two operation modes: the 3way network mode (NW) and the standard mode (STD). You can switch between modes as desired. Initially, the DSP setting is set to the standard mode (STD). ! After switching, reset the microprocessor. En 3Page 2Page 4