Before installing this product • Use this unit with a 12-volt battery and negative earthing only. Failure to do so may result in a fire or malfunction. • To avoid shorts in the electrical system, be sure to disconnect the (–) battery cable before installation. To prevent damage WARNING • Use speakers over 50 W (maximum input power) and between 4 Ω to 8 Ω (impedance value). Do not use 1 Ω to 3 Ω speakers for this product. • The black lead is earth. Please earth this lead separately from the earth of high current products such as power amps. Do not earth more than one product together with the earth from another product. For example, you must separately earth any amp unit away from the earth of this product. Connecting earths together can cause a fire and/or damage the products if their earths became detached. • When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. • When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector. • This product cannot be installed in a vehicle without ACC (accessory) position on the ignition switch. ACC position No ACC position • To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit. • Attach the connectors of the same colour to the corresponding coloured port, i.e., blue connector to the blue port, black to black, etc. • For connecting a power amp or other devices to this product, refer to the manual for the product to be connected. • Since a unique BPTL circuit is employed, do not directly earth the side of the speaker lead or connect the side of another side of the speaker lead together. Be sure to connect the side of the speaker lead to the side of the speaker lead on this product. • The graphical symbol placed on the product means direct current. Notice for the blue/ white lead • When the ignition switch is turned on (ACC ON), a control signal is output through the blue/white lead. Connect to an external power amp’s system remote control terminal, the auto-aerial relay control terminal, or the aerial booster power control terminal (max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even if the audio source is switched off. • Be sure not to use this lead as the power supply lead for the external power amps. Such connection could cause excessive current drain and malfunction. • Be sure not to use this lead as the power supply lead for the auto-aerial or aerial booster. Such connection could cause excessive current drain and malfunction. Important When this product is in [Power OFF] mode, the control signal is also turned off. If [Power OFF] mode is cancelled, the control signal is output again and the aerial is extended with the auto aerial function (if the aerial is being used). Be careful so that the extended aerial does not come into contact with any obstacles. Rear panel (main terminals) WARNING • To avoid the risk of accident and the potential violation of applicable laws, this product should never be used while the vehicle is being driven except for navigation purposes. And, also rear displays should not be in a location where it is a visible distraction to the driver. • In some countries, the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply they must be obeyed and this product’s video source should not be used. GPS aerial 3.55 m Microphone 3 m Vehicle Bus conversion cable 13 cm*. Refer to the instruction manual for the Vehicle Bus adapter (sold separately). Digital Radio aerial input* This product Aerial jack AV cable IN/OUT Power supply Fuse (10 A) Wired remote input Hard-wired remote control adapter can be connected (sold separately). * AVIC-Z930DAB/AVIC-Z830DAB/AVICZ730DAB/AVIC-Z7330DAB CAUTION For improved Digital Radio reception, make sure a Digital Radio aerial with phantom power input (active type) is used. Pioneer recommends using AN-DAB1 or CA-AN-DAB.001 (sold separately). Current consumption of the Digital Radio aerial should be 100 mA or less. Power cord WARNING IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY En 3 English
Download PDF file