V DC). The control signal is output through the blue/white lead, even if the audio source is switched off. Important When this product is in [Power OFF] mode, the control signal is also turned off. If [Power OFF] mode is cancelled, the control signal is output again and the aerial is extended with the auto aerial function (if the aerial is being used). Be careful so that the extended aerial does not come into contact with any obstacles. Rear panel (main terminals) Aerial jack This product Pre out supply Power supply Fuse (10A) RGB cable (supplied with Navigation system) Pioneer navigation system Contact your dealer to inquire about the connectable navigation unit. Wired remote input Hard-wired remote control adaptor can be connected (sold separately). Power cord WARNING IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE'S ANTILOCK BRAKING SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION. GPS aerial 3.55 m Microphone 3 m Vehicle Bus conversion input Refer to the instruction manual for the Vehicle Bus adapter (sold separately). Monitor cable connector Connect to LCD screen. Digital Radio aerial input To power supply Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1* to 4* and 3* to 2*. Yellow (2*) Back-up (or accessory) Yellow (1*) Connect to the constant 12 V supply terminal. Red (4*) Accessory (or back-up) Red (3*) Connect to terminal controlled by ignition switch (12 V DC). Connect leads of the same colour to each other. Orange/white To lighting switch terminal. Black (earth) To vehicle (metal) body. Blue/white (5*) The pin position of the ISO connector will differ depending on the type of vehicle. Connect 5* and 6* when Pin 5 is an aerial control type. In another type of vehicle, never connect 5* and 6*. Blue/white (6*) Connect to auto-aerial relay control terminal (max. 300 mA 12 V DC). Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Pink Car speed signal input Light green Used to detect the ON/OFF status of the handbrake. This lead must be connected to the power supply side of the handbrake switch. If this connection is made incorrectly or omitted, certain functions of this product will be unusable. Connection method Clamp the lead (1) then clamp firmly with needle-nosed pliers (2). Power supply side Handbrake switch Earth side Speaker leads White: Front left + or high range left + White/black: Front left – or high range left – En 3 English
Download PDF file