Hard Wire Kit RD-HWK100 Installation Manual Thank you for buying this Pioneer product. Please read through these instructions so you will know how to operate your model properly. After you have finished reading the instructions, keep this document in a safe place for future reference. Be sure to disconnect the terminal of the vehicle’s battery before connecting the power or AV cable. Handling precautions • Be sure to install this product correctly according to this instruction manual. Installation other than specified may cause an accident or injury. In this case, Pioneer does not take any responsibility. • When installing this product, also read the “Safety Precautions” for the compatible Dash Camera to which this product is to be installed. Important safeguards WARNING • Any obstruction of or other interference with the airbag, either deployed or non-deployed, or with the clear view of the road must be avoided and, accordingly, professional installation is required. • Do not allow this product to come into contact with liquids. Electrical shock could result. Also, damage to the product, smoke, and overheating could result from contact with liquids. • Do not disassemble or modify this product, as there are high-voltage components inside which may cause an electric shock. Be sure to consult your dealer or the nearest authorised Pioneer Service Station for internal inspection, adjustments or repairs. • Do not use this product in locations subjected to high temperatures of 60°C or higher, low temperatures of –10°C or lower, or high humidity. Precautions before connecting the system CAUTION • Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed. • Make sure that the cables and wires will not interfere with or become caught in any of the vehicle’s moving parts, especially the steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any of the vehicle’s controls. • Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires may become damaged, resulting in a short circuit or malfunction and permanent damage to the product. • Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may fail to work properly. • Never feed power to other electronic products by cutting the insulation of the power supply cable of this product and tapping into the cable. The current capacity of the cable will be exceeded, causing overheating. To prevent damage WARNING • When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. Precautions before installation (I) CAUTION • Never install this product in places where, or in a manner that: - Could injure the driver or passengers if the vehicle stops suddenly. - May interfere with the driver’s operation of the vehicle, such as on the floor in front of the driver’s seat, or close to the steering wheel or gearstick. • To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts are not supplied with this product, use compatible parts in the manner specified after you have the parts’ compatibility checked by your dealer. If parts other than supplied or compatible ones are used, they may damage internal parts of this product or they may work loose and the product may become detached. English
Share
Print
Download PDF file
