Connection This product 1 2 4* 3* Power cord 2 2* 1* 1 3 7 8 9 5 4 6 87 65 4 3 1 Microphone 3 m (MVH-AV280BT) 2 This product 3 Aerial jack 4 Wired remote input Hard-wired remote control adapter can be connected (sold separately). 5 Power supply 6 Fuse (10 A) 7 Front output 8 Rear output or subwoofer output c a (5*) b (6*) d e f 1. 2. h g i k j 1 To power supply 2 Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1* to 4* and 3* to 2*. 3 Yellow (2*) Back-up (or accessory) 4 Yellow (1*) Connect to the constant 12 V supply terminal. 5 Red (4*) Accessory (or back-up) 6 Red (3*) Connect to terminal controlled by ignition switch (12 V DC). 7 Connect leads of the same colour to each other. 8 Orange/white To lighting switch terminal. 9 Black (earth) To vehicle (metal) body. a Blue/white (5*) The pin position of the ISO connector will differ depending on the type of vehicle. Connect 5* and 6* when Pin 5 is an aerial control type. In another type of vehicle, never connect 5* and 6*. b Blue/white (6*) Connect to auto-aerial relay control terminal (max. 300 mA 12 V DC). c Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). d Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwardss or backwardss. e Light green Used to detect the ON/OFF status of the handbrake. This lead must be connected to the power supply side of the handbrake switch. f Connection method 1 Clamp the lead. 2 Clamp firmly with needle-nosed pliers. g Power supply side h Handbrake switch i Earth side j Speaker leads White: Front left + White/black: Front left – Grey: Front right + Grey/black: Front right – Green: Rear left + Green/black: Rear left – 3
Download PDF file