• For connecting a power amp or other devices to this product, refer to the manual for the product to be connected. • The graphical symbol placed on the product means direct current. Notice for the blue/ white lead • When the ignition switch is turned on (ACC ON), a control signal is output through the blue/white lead. Connect to an external power amp’s system remote control terminal, the auto-aerial relay control terminal, or the aerial booster power control terminal (max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even if the audio source is switched off. Rear panel Subwoofer output Power cord Microphone 3 m (MVH-A200VBT) This product Aerial jack Wired remote input Connect to steering wheel control interface of your vehicle. For more details, consult your dealer. Power supply Fuse (10 A) Front output Rear output To power supply Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1* to 4* and 3* to 2*. Yellow (2*) Back-up (or accessory) Yellow (1*) Connect to the constant 12 V supply terminal. Red (4*) Accessory (or back-up) Red (3*) Connect to terminal controlled by ignition switch (12 V DC). Connect leads of the same colour to each other. Orange/white To lighting switch terminal. Black (earth) To vehicle (metal) body. Blue/white (5*) The pin position of the ISO connector will differ depending on the type of vehicle. Connect 5* and 6* when Pin 5 is an aerial control type. In another type of vehicle, never connect 5* and 6*. Blue/white (6*) Connect to auto-aerial relay control terminal (max. 300 mA 12 V DC). Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Light green Used to detect the ON/OFF status of the handbrake. This lead must be connected to the power supply side of the handbrake switch. Connection method Clamp the lead (1) then clamp firmly with needle-nosed pliers (2). Power supply side Handbrake switch Earth side Speaker leads White: Front left + or high range left + White/black: Front left – or high range left – Grey: Front right + or high range right + Grey/black: Front right – or high range right – Green: Rear left + or middle range left + Green/black: Rear left – or middle range left – Violet: Rear right + or middle range right + Violet/black: Rear right – or middle range right – ISO connector In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. NOTES • The position of the handbrake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. • When a subwoofer is connected to this product instead of a rear speaker, change the rear output setting in the initial setting. The subwoofer output of this product is monaural. • When using a subwoofer of 2 Ω, be sure to connect the subwoofer to the violet and violet/black leads of this unit. Do not connect anything to the green and green/black leads. Power amp (sold separately) Without internal amp Important The speaker leads are not used when this connection is in use. En 3 English
Download PDF file