Menu Item LOCAL Description Menu Item EQ SETTING Description FM: [OFF], [LV1], [LV2], [LV3], [LV4] Restrict the tuning station according to the MW/LW: [OFF], [LV1], [LV2] signal strength. TA [ON], [OFF] AF [ON], [OFF] Allow the unit to retune to a different frequency providing the same station. (Available only when FM band is selected.) Interrupt the currently selected source with news programs. (Available only when FM band is selected.) Assign or buttons to seek the stations one by one (manual tuning) or select a station from the preset channels. USB Receive current traffic information if available. (Available only when FM band is selected.) [SUPER BASS], [POWERFUL], Select or customize the equalizer curve. [NATURAL], [VOCAL], [CUSTOM1], [CUSTOM1] can be set separately for each source. [CUSTOM2], [FLAT] However, each of the below combinations are set to the same setting automatically. Select an equalizer band and [CUSTOM2] is a shared setting used for all level for further customizing. sources. Equalizer band: [80HZ], [250HZ], You can also switch the equalizer by pressing [800HZ], [2.5KHZ], [8KHZ] repeatedly. Equalizer level: [+6] to [–6] LOUDNESS [OFF], [LOW], [MID], [HI] SUB.W*2 [NOR], [REV], [OFF] SUB.W CTRL*2*3 Cut-off frequency: [50HZ], [63HZ], [80HZ], [100HZ], [125HZ], [160HZ], [200HZ] Output level: [–24] to [+6] Slope level: [–12], [–24] BASS BOOST [0] to [+6] HPF SETTING Cut-off frequency: [OFF], [50HZ], Only frequencies higher than the high-pass filter [63HZ], [80HZ], [100HZ], [125HZ], (HPF) cutoff are output from the speakers. [160HZ], [200HZ] Slope level: [–12], [–24] SLA [+4] to [–4] Adjust the volume level for each source except FM. Select the bass boost level. Only frequencies lower than those in the selected range are output from the subwoofer. Select the subwoofer phase. Compensate for clear sound at low volume. NEWS [ON], [OFF] SEEK [MAN], [PCH] S.RTRV [1] (effective for low compression Enhance compressed audio and restore rich rates), [2] (effective for high sound. (Not available when the FLAC file is compression rates), [OFF] played back.) AUDIO settings Menu Item FADER*1 Adjust the front and rear speaker balance. BALANCE Adjust the left and right speaker balance. Description *1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5). *2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5). *3 Not available when [OFF] is selected in [SUB.W]. 8 En
Download PDF file