Connecting the power cord Pioneer navigation system RGB cable (supplied with navigation system) 4m This product Microphone English Please contact your dealer to inquire about the connectable navigation unit. Note: Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1* to 4* and 3* to 2*. 2* 1* Fuse (10 A) 4* 3* Connect leads of the same color to each other. Vehicle Bus adapter input Please refer to the instruction manual for the Vehicle Bus adapter (sold separately). Vehicle Bus conversion cable 15.8 cm Wired remote input Hard-wired remote control adapter can be connected (sold separately). Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. Connection method 1. Clamp the lead. 2. Clamp firmly with needle-nosed pliers. Aerial jack Power supply Power cord Yellow (2*) Back-up (or accessory) Yellow (1*) Connect to the constant 12 V supply terminal. Note: · The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Light green (PARKING BRAKE) Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). Parking brake switch Red (4*) Accessory (or back-up) Red (3*) Connect to terminal controlled by ignition switch (12 V DC). Orange/white To lighting switch terminal. Black (ground) To vehicle (metal) body. Power supply side Ground side ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Speaker leads White: White/black: Gray: Gray/black: Green: Green/black: Violet: Violet/black: Front left Front left Front right Front right Rear left Rear left Rear right Rear right Blue/white (5*) Blue/white (6*) Connect to auto-antenna relay control terminal (max. 300 mA 12 V DC). The pin position of the ISO connector will differ depending on the type of vehicle. Connect 5* and 6* when Pin 5 is an antenna control type. In another type of vehicle, never connect 5* and 6*. Note Make sure to connect the microphone supplied with this product when using Android Auto. 3 En
Download PDF file