through the blue/white lead, even if the audio source is switched off. Rear panel Power cord This product Aerial jack Wired remote input Connect to steering wheel control interface of your vehicle. For more details, consult your dealer. Power supply Fuse (10 A) Front output Rear/Subwoofer output To power supply Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1* to 4* and 3* to 2*. Yellow (2*) Back-up (or accessory) Yellow (1*) Connect to the constant 12 V supply terminal. Red (4*) Accessory (or back-up) Red (3*) Connect to terminal controlled by ignition switch (12 V DC). Connect leads of the same colour to each other. Orange/white To lighting switch terminal. Black (earth) To vehicle (metal) body. Blue/white (5*) The pin position of the ISO connector will differ depending on the type of vehicle. Connect 5* and 6* when Pin 5 is an aerial control type. In another type of vehicle, never connect 5* and 6*. Blue/white (6*) Connect to auto-aerial relay control terminal (max. 300 mA 12 V DC). Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Light green Used to detect the ON/OFF status of the handbrake. This lead must be connected to the power supply side of the handbrake switch. Connection method Clamp the lead (1) then clamp firmly with needle-nosed pliers (2). Power supply side Handbrake switch Earth side Speaker leads White: Front left + or high range left + White/black: Front left – or high range left – Grey: Front right + or high range right + Grey/black: Front right – or high range right – Green: Rear left + or middle range left + Green/black: Rear left – or middle range left – Violet: Rear right + or middle range right + Violet/black: Rear right – or middle range right – ISO connector In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. NOTE The position of the handbrake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Power amp (sold separately) Without internal amp Important The speaker leads are not used when this connection is in use. En 3 English
Download PDF file