Menu Item [Day] [Night] [Dimmer Duration] Description Turns the dimmer function to off. Turns the dimmer function to on. Adjust the time that the dimmer is turned on or off by dragging the cursors or touching or . You can use this function when [Dimmer Trigger] is set to [Time]. TIPS • Each touch of or moves the cursor backwards or forwards in the 15 minute width. • When the cursors are placed on the same point, the dimmer available time is 0 hours. • When the cursor for off time setting is placed on the left end and the cursor for on time setting is placed on the right end, the dimmer available time is 0 hours. • When the cursor for on time setting is placed on the left end and the cursor for off time setting is placed on the right end, the dimmer available time is 24 hours. NOTE The time display of the dimmer duration adjusting bar depends on the clock display setting (page 47). [Picture Adjustment] You can adjust the picture for each source and rear view camera. CAUTION For safety reasons, you cannot use some of these functions while your vehicle is in motion. To enable these functions, you must stop in a safe place and apply the handbrake. To adjust following menu, touch , , , to adjust. Menu Item [Brightness] [-24] to [+24] [Contrast] [-24] to [+24] [Colour]* [-24] to [+24] [Hue]* [-24] to [+24] [Dimmer] [+1] to [+48] Description Adjust the black intensity. Adjust the contrast. Adjust the colour saturation. Adjust the tone of colour (which colour is emphasised, red, or green). Adjust the brightness of the display. 40 En Menu Item [Temperature] [-3] to [+3] Description Adjust the colour temperature, resulting in a better white balance. * With some pictures, you cannot adjust [Hue] and [Colour]. NOTES • The adjustments of [Brightness], [Contrast], and [Dimmer] are stored separately when your vehicle's headlights are off (daytime) and on (nighttime). • [Brightness] and [Contrast] are switched automatically depending on the setting of [Dimmer Settings]. • [Dimmer] can be changed the setting or the time to switch it to on or off (page 39). • The picture adjustment may not be available with some rear view cameras. • The setting contents can be memorised separately. [System Information] Menu Item [Firmware Information] [Firmware Update] Description Displaying the firmware version. CAUTION • The USB storage device for updating must contain only the correct update file. • Never turn this product off, disconnect the USB storage device while the firmware is being updated. • You can only update the firmware when the vehicle is stopped and the handbrake is engaged. 1 Download the firmware update files into your computer. 2 Connect a blank (formatted) USB storage device to your computer then locate the correct update file and copy it onto the USB storage device. 3 Connect the USB storage device to this product (page 26). 4 Turn the source off (page 16). 5 Display the [System] setting screen (page 37). 6 Touch [System Information]. 7 Touch [Firmware Update]. 8 Touch [Continue]. Follow the on-screen instructions to finish updating the firmware. NOTES • This product will reset automatically after the firmware update is completed if the update is successful. • If an error message appears on the screen, touch the display and perform the above steps again.
Download PDF file